Last night I upgraded my stock S3 hard drive with a WD 1 TB Drive (WD10EVDS). I saw on TC that this was one of the drives that works without any problems. I copied the stock drive over to the new drive using MFSLive (not WinMFS). I issued the following command to perform the copy.
backup -qTao - /dev/sda | restore -s 128 -xzpi - /dev/sdb
During the backup I did receive one error however, the backup seemed to go ok otherwise (take a look at the attached screenshots). When I put the new hd into my Series 3 the DVR wouldn't completely boot. The lights on the front are all lit however, the device isn't showing anything on my TV. Does anybody have any idea what the problem could be?
Thanks!
